25
Chapter1 Product Overview
Setting Auto Nozzle Check Interval
Specify the number of printouts to let the printer run the nozzle check when reached the number. The printer
will stop while running the check.
How to Set
Set using the operation panel of the printer, or using PrinterSetting.
Specify the number in the range of 1 to 13000.
See
"Operation Panel Settings" on page 145 or "PrinterSetting" on page 113.
Setting Threshold of Nozzle Clogging
Specify the threshold of nozzle clogging. If the number of detected clogged nozzles exceed the threshold, a mes-
sage is displayed on the printer’s screen. You can set to run an auto head cleaning in such a case. If the number
of clogged nozzles is below the threshold, you can use the supplemental printing function.
How to Set
Set using the operation panel of the printer, or using PrinterSetting.
Specify the number in the range of 0 to 16 nozzles.
See
"Operation Panel Settings" on page 145 or "PrinterSetting" on page 113.
Setting Auto Cleaning after Nozzle Check
You can set to run an auto head cleaning when the number of detected clogged nozzles exceeds the threshold.
When this setting is enabled: A message is displayed on the printer’s screen and the cleaning is run automati-
cally when the number of detected clogged nozzles exceeds the threshold.
When this setting is disabled: A message is displayed on the printer’s screen when the number of detected
clogged nozzles exceeds the threshold, but the cleaning is not run.
How to Set
Set using the operation panel of the printer, or using PrinterSetting.
The factory default is “Enable”.
See
"Operation Panel Settings" on page 145 or "PrinterSetting" on page 113.
• The count of printouts is reset when the specified number is reached and nozzle check is performed,
and when the printer is turned off.
• The factory default is “500”.
• The number of nozzles is the total of four color (BK, C, M, Y) nozzles.
• The factory default is “6”.
To Next Page
Loading...
Need help?
General
