121
How to Adjust the Cut Position
Adjust the cut position to match the media form used.
When using media with a perforated line, adjust the cut position so that the perforated line is
not cut.
Media Form Description
Die-cut label (Gap)
• When the adjustment value is +, the cut position moves closer to the
reference position (print start position).
• When the adjustment value is –, the cut position moves away from the
reference position (print start position).
Backing paper
Label
Label
Refer
ence position
(print start position)
Cut position
Printable area
Paper feed
direction
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
