171
Paper type Plain paper label / matte paper label / glossy paper label:
Form Roll paper
Backing paper width 30 to 112 mm
Label width 25.4 to 108 mm
Label length 8 to 1117.6 mm
Gap between labels 3 to 6 mm
Waste part on the left and right 2 ± 0.5 mm
Waste width 1.5 mm or more
Label corner R 1.5 mm or less
Black mark width 13 mm or more
Black mark length 4 mm or more (margin part 4 mm or more)
Black mark center position 8.5 ± 1 mm
Black mark interval 11 to 1123.6 mm
Paper thickness Plain paper label / matte paper label:
0.129 to 0.143 mm
Glossy paper label:
0.184 mm
Roll paper core Plain paper label:
Outer diameter: 44.1 mm or more
Matte paper label / glossy paper label:
Outer diameter: 56.8 mm or more
Outer diameter Max. 101.6 mm
Winding direction Printing surface must be facing outside.
c IMPORTANT
• Paper with holes or cutouts cannot be used.
• For the black mark position of the die-cut label paper, match the label
leading edge to the black mark leading edge.
• Both types, paper without waste part and paper without the left and right
waste parts, can be used.
Q Note
Depending on the shape of die-cut labels, the labels may peel off their
backing paper inside the printer. When you want to use die-cut labels that do
not meet the specifications, contact your dealer for advice.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
