80
5 Media Saving (continuous paper and full-page labels only)
Select the media saving setting of the paper. You can set not to create margins before and after the print
data for one page.
• No Saving: Creates margins at the top and bottom parts of print data because the paper is fed before
the start of printing and after the end of printing.
• Eliminate Lower Margin: Does not create a margin at the bottom part of print data because the
paper is not fed after the end of printing.
• Eliminate Lower And Upper Margin: Does not create margins at the top and bottom parts of print
data because the paper is not fed before the start of printing and after the end of printing.
6 Media Coating Type
Select the paper type. (U "List of Paper That Can Be Used" on page 19)
7 Print Quality
Select the print quality.
• Speed: 360 x 360 dpi
• Quality (Mode1): 720 x 360 dpi
• Quality (Mode2): 720 x 360 dpi
The print speed varies depending on the print quality. (U "Specification" on page 161)
Top margin
Print data
Bottom margin
Paper feed
direction
Q Note
If you select Auto Cut in Settings For Paper Handling After Print, 15 mm
will be provided even if the paper length is the minimum. When the print
data is less than 15 mm, the margins remain even if you set Eliminate
Lower Margin or Eliminate Lower And Upper Margin.
Minimum paper
length: 15 mm
Print data length
Margin
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
