ETAS ES910.3-A - Page 17

ES910.3-A - User’s Guide 17
ETAS Hardware Description
• Equipment with universal ECU interfaces:
– One ETK ECU interface for bypass, measure and calibration applica-
tions
– Two CAN interfaces (High-Speed or Low-Speed) for bypass applica-
tions
– Two LIN interfaces for measure and Rapid prototyping applications
• Equipping with a configurable Ethernet interface:
– for an XETK for bypass, measurement and calibration applications or
– for an ECU with Ethernet interface (XCP on UDP) for
bypass, measurement and calibration applications or
– for the XCP-on-Ethernet interface iLinkRT
TM
for fast measurement and
calibration privileges (application with INCA-MCE)
• Equipping with a configurable IO interface:
– for ES400 Micro I/O & Measurement Modules for Rapid Prototyping
applications or
– for standardized, real time-capable automation bus as EtherCAT-slave
device for fast measurement and calibration privileges (application
with INCA-MCE)
• Support of the ETAS synchronization mechanism at the interfaces PC
(SYNC IN functionality) and ECU (SYNC OUT functionality)
• EtherCAT selectable as source for ETAS synchronization mechanism
• One slot for extension modules (extension slot)
• Module suitable for use in automotive applications; suitable for use in the
development environment and in the vehicle on test drives.
– Channels galvanically isolated from each other, from the device
ground and from the supply voltage
– Not sensitive to extreme environmental conditions (temperature, EMC)
– Wide range of power supply
– High mechanical stability and durability
• Member of the ETAS Tool Suite
– Rapid prototyping of control functions with MATLAB®/Simulink®,
ASCET-MD, and C by integration in INTECRIO
– Supported by INCA, INCA ES9xx Add-On, INCA-EIP, RTA-TRACE, HSP
For the complete technical data of the ES910.3-A, refer to the chapter "Techni-
cal Data" on page 74.