ETAS ES910.3-A - Use of Open Source Software; System Requirements; Hardware

ES910.3-A - User’s Guide 77
ETAS Technical Data
7.5 Use of Open Source Software
The product uses Open Source Software (OSS). This software is installed in the
product at the time of delivery and does not have to be installed or updated by
the user. Reference shall be made to the use of the software in order to fulfill
OSS licensing terms. Additional information is available in the document "OSS
Attributions List" at the ETAS website www.etas.com
.
7.6 System Requirements
7.6.1 Hardware
Operation of the ES910.3-A requires a power supply voltage of 7 V to 29 V DC.
Ethernet Interface of the PC
A PC with a free Ethernet interface (1 Gbit/s or 100 Mbit/s, Full Duplex) with an
RJ-45 connection is required.
Prerequisite for successful initialization of the module
Deactivating the power-save mode:
In Control Panel / Device Manager / Network Adapter, select the network
adapter used with a double-click. On the "Power Management" tab, deactivate
the option "Allow the computer to turn off this device to save power“. Confirm
your configuration.
The manufacturers of the network adapters provide different names for this
function.
Example:
• "Link down Power saving"
• "Allow the computer to turn off this device to save power."
Firmware of the Modules mountable in the Extension Slot
Note
It is absolutely necessary to deactivate the function for automatic switching to
power-save mode of your PC network adapter if there is no data traffic at the
Ethernet interface!
Note
As delivered, the ES910.3-A module contains no firmware to support the mod-
ules mountable in the extension slot.

The required firmware has to be loaded additionally (see chapter 4.17
on page 41).