ETAS ES910.3-A - Assembly and Locking; Fixing a Module Onto a Carrier System; Fig. 5-2 Levering off the Plastic Foot

ES910.3-A - User’s Guide 44
ETAS Getting Started
5.3 Assembly and Locking
5.3.1 Fixing a Module onto a Carrier System
The ES910.3-A has a rugged metal housing with nonskid plastic feet. The unit
can easily be screwed onto a carrier system for installation in a vehicle or in the
lab.
The screw thread for attaching your device is already contained in the housing
and is easily accessible.
To fasten the ES910.3-A housing:
• Remove the plastic feet from the bottom of the
module by pushing a minus screwdriver between
the housing bottom and the plastic foot. Lifting off
the plastic foot using the screwdriver as a lever.
Fig. 5-2 Levering Off the Plastic Foot
• A threaded hole will become visible under the plas-
tic foot.
The threads for fastening the module are located
both on the bottom of the ES910.3-A housing.
CAUTION!
Heat concentration on the long sides of the module. 
The electronics can be damaged due to overheating. 
Do not cover ventilation slits when setting up, assembling or connect-
ing with other modules. Adhere to the minimum distance at the sides.