ETAS ES910.3-A - Acoustic Signal

ES910.3-A - User’s Guide 24
ETAS Hardware Description
ECU Interface
An LED T and an LED S are assigned to the interface PC (see Fig. 3-3
on page 20).
PC Interface
An LED T and an LED S are assigned to the interface PC (see Fig. 3-3
on page 20).
3.5 Acoustic Signal
The ES910.3-A has an acoustic signal generator.
Emitting an Acoustic Signal
• Short signal when booting the ES910.3-A.
• Linked to the °C indicator, temperature states of the module are indi-
cated:
– Sequence of short signals when critical temperature is reached
– Permanent signal when critical temperature is exceeded
• Further customized configurations are possible in INTECRIO.
E Off Module in state INIT
Red, blinking
(slow)
Module in state PRE-OPERATIONAL
Red, single flash Module in state SAFE-OPERATIONAL
Red Module in state OPERATIONAL
Red, flickering
(fast)
Module in state BOOTSTRAP
LED Display Functional State
T Yellow Communication at the interface
Off Communication interrupted
S Green 1 Gbit/s Communication
Yellow 100 Mbit/s communication
Off Communication interrupted
LED Display Functional State
T Yellow Communication at the interface
Off Communication interrupted
S Green 1 Gbit/s Communication
Yellow 100 Mbit/s communication
Off Communication interrupted
LED Display Functional State