ETAS ES910.3-A - ETK Interface (ETK)

ES910.3-A - User’s Guide 83
ETAS Technical Data
7.7.6 ETK Interface (ETK)
Support of Service-Based Bypass V3.0 depending on the ETK Type
Operating modes Basic, Compatibility, Advanced
ETK protocol speed 8 Mbit/s / 100 Mbit/s
ETK protocol transfer Single Mode / Block Mode
Bypass support Hooked-Based Bypass
Service-Based Bypass V2.0
Service-Based Bypass V3.0
(for notes about the support of ETK
types, see the table below)
Note
ES910.3-A supports all current ETK types. 
Exception: 
The ETK types not supported by ES910.3-A are listed in the following table.
Detailed information can be found on the Internet pages of ETAS GmbH (ETK
System Feature PDF document).
ETKs not supported by ES910.3-A ETKM,
ETK3.x,
ETK4,
ETK6.x,
ETK7.0,
ETK8.0,
ETK8.1
μETK1,
μETK2
ETKS1.0-A,
ETKS1.0-B
ETKP1.0
Note
The type of support of Service-Based Bypass V3.0 by different ETK types is
listed in the following table. Detailed information can be found on the Internet
pages of ETAS GmbH (ETK System Feature PDF document).