3025SW Master Control Switching & Channel Branding
Revision 1.0 Page 139
If Reverse Move: Either start fading the audio at the start of the move reverse or end of the move
reverse.
Shuffler Layout: This allows for a stored shuffle profile to be applied to the Background audio
during the DVE move.
7.2.2.6. Options
One of the options for the DVE move is to link moves together. This control allows for the DVE move to
trigger other DVE moves when it’s completed.
Figure 7-5: Options Tab
Next Move: Select which DVE move to trigger once this DVE move is completed
Delay: This is the delay (fields or frames depending on the video standard) to wait before triggering the
next DVE move. 0 will select the next move only
.
Take Off-air At End of Move: This will take the DVE Move off air when it is completed.
Take Off-Air on move reverse: This will configure the Move to go off-air at the end of the move reverse
or not. Previously a DVE that returned to full screen on reverse would go off-air automatically, however
now if a move is to go off-air on move reverse this checkbox is required.
DVE move off: When this is set all of the DVE Start Frame and End Frame settings will become
unavailable. This setting configures the DVE move to go off-air when the DVE move is executed.
7.2.2.7. DVE SCALING AND CROPPING
Both the start and end frames of the DVE move can have scaling applied. By default when a DVE move
is created using the DVE Move Manager in EMC-Setup both the start frame and end frame will be full
screen, i.e. X=100% and Y=100%.
In order to scale the Foreground source for the DVE (as configured in the DVE Move) the user must
apply a horizontal scale percentage/number of pixels (X) and a vertical scale percentage/number of
pixels(Y).
To Next Page
Loading...
