evertz 3025SW - Stopping the Up;Down Timer

3025SW Master Control Switching & Channel Branding
Page 190 Revision 1.0
9.5.3. Stopping the Up/Down Timer
Stopping the Up/Down timer is configured by using the following playlist script command:
--------------------------------------------------------------------------------------------------------------------------------------------
cmd udt_stop(“s”)
where
- “s” is the up/down timer to be stopped. This is either 1 (timer 1) or 2 (timer 2).
--------------------------------------------------------------------------------------------------------------------------------------------
9.5.3.1. Example - Stop Counting Down After 20 Seconds
This is an extension to the previous example in section 9.6.1.2.
--------------------------------------------------------------------------------------------------------------------------------------------
# VSSL PLAYLIST
cmd udt_param(“2 timer 1 direction 30 min 00 sec”)
cmd udt_reload(“2”)
cmd media_in(“timer2”)
cmd udt_start(“2”)
cmd wait_for(“20 s”)
cmd udt_stop(“2”)
--------------------------------------------------------------------------------------------------------------------------------------------
In this example, timer 2 is reloaded (reset) to be a down timer starting at 30 minutes 00 seconds. The
timer starts at 30 minutes 00 seconds and counts down for 20 seconds at which point it stops and
displays 29 minutes 40 seconds (29:40).
9.5.3.2. Stop Counting Down After 20 Seconds Then Go Off-Air
--------------------------------------------------------------------------------------------------------------------------------------------
# VSSL PLAYLIST
cmd udt_param(“2 timer 1 direction 30 min 00 sec”)
cmd udt_reload(“2”)
cmd media_in(“timer2”)
cmd udt_start(“2”)
cmd wait_for(“20 s”)
cmd udt_stop(“2”)
cmd wait_for(“1 s”)
cmd media_out(“timer2”)
--------------------------------------------------------------------------------------------------------------------------------------------