evertz 3025SW - EAS Configuration

3025SW Master Control Switching & Channel Branding
Revision 1.0 Page 95
gpo_act="logo_status"
}
obj gpo_config("7")
{
gpo_act="logo_status"
}
obj gpo_config("8")
{
gpo_act="logo_status"
}
obj gpo_config("9")
{
gpo_act="logo_status"
}
obj gpo_config("10")
{
gpo_act="logo_status"
}
obj gpo_config("11")
{
gpo_act="logo_status"
}
obj gpo_config("12")
{
gpo_act="logo_status"
}
obj gpo_config("13")
{
gpo_act="logo_status"
}
obj gpo_config("14")
{
gpo_act="logo_status"
}
obj gpo_config("15")
{
gpo_act="logo_status"
}
4.16. EAS
This section configures the Emergency Alert System (+E) option. The +E option is only available in
North America. A typical system would use an EAS device externally to the 3025SW. The EAS device
will send the EAS alert text over a serial or IP interface based on the device. This tab configures the
properties of the EAS crawl itself. To set up an EAS system, please refer to section 8.2.1.