3025SW Master Control Switching & Channel Branding
Revision 1.0 Page 17
2.9.2. AES / MADI INPUTS and OUTPUTS
IN 1: VO 1 AES 1. This is for Voiceover 1 AES channels 1 and 2 when configured as AES by
default.
IN 2: VO 1 AES 2. This is for Voiceover 1 AES channels 3 and 4 when configured as AES by
default.
IN 3: VO 2 AES 1. This is for Voiceover 2 AES channels 1 and 2 when configured as AES by
default.
IN 4: VO 2 AES 2. This is for Voiceover 2 AES channels 3 and 4 when configured as AES by
default.
OUT 1: MADI Output 1. This is not supported on the 3025SW.
OUT 2: MADI Output 2. This is not supported on the 3025SW.
OUT 3: MADI Output 3. This is not supported on the 3025SW.
OUT 4: MADI Output 4. This is not supported on the 3025SW.
2.9.3. AUDIO
2.9.3.1. Audio Connections – Embedded (Serial Video)
The 3025SW supports 16 channels of embedded audio from any of the 14 video inputs. The 3025SW
also supports 16 channels of embedded audio from up to five inputs at any time which can be used as
for voiceovers. These inputs need to be pre-configured in the EMC-Setup software. Inputs can operate
as PGM/PST inputs and/or be assigned as a de-embedder source for voiceovers at the same time.
2.9.3.2. Audio Connections – Discrete
The only discrete audio inputs currently supported on the 3025SW are MADI inputs which are used
exclusively for discrete voiceovers. If discrete audio I/O is required for PGM/PST or if additional
voiceover discrete voiceover inputs are required please contact the factory for more information.
2.9.4. AUX IO-1 and AUX IO-2
There is one breakout panel provided with each 3025SW module. In order to access additional serial I/O
connections, connect the breakout panel (using the provided cable) to the AUXIO-1 connector. This will
allow the user to access LTC IN, GPIO, DB1, DB2, DB3, and DB4. See section 0 for a description of the
different ports. A secondary breakout panel can be added (optional) to AUXIO-2 connector; this
provides the user access to GPIO, DB5 and DB6.
To Next Page
Loading...
