3025SW Master Control Switching & Channel Branding
Page 64 Revision 1.0
4.8.1.1. Name
This name field will appear on any keyer function buttons on the EMC control panel. This name is edited
in two rows of five characters, this matches the display capability of the LCD buttons used on the EMC
control panels. The keyer name should ideally be only 5 characters in length as the second row of the
keyer level buttons are used to indicate whether the keyer is on-air or not.
4.8.2. Options
4.8.2.1. On-Air by Default
This option selects whether this keyer will be on-air if the 3025SW channel has a power cycle or re-
configuration.
Please note: The Internal Branding Keyer is always On-Air. Any media that is
faded-in or cue’d will be visible without any keyer level or keyer on-air controls.
4.8.2.2. On-Air on Emergency
This option selects whether this keyer will be on-air if the 3025SW channel has its emergency input put
on-air.
4.8.2.3. Hold Transition Level
If the keyer is on preset, after the next keyer transition the keyer will automatically be placed into a
transitional state. On the next keyer transition the keyer will be placed into a completely off-air and
non-transitional state. This is similar to the “Flip-Flop” but is only designed to bring a keyer on-air for a
specified single event.
4.8.2.4. Off-Air on Hot Cut
This option selects whether this keyer will be taken off-air if the program bus is changed by a "Hot-
Cut".
4.8.2.5. Allow Key Transitions During
When the 3025SW is put into the emergency mode the 3025SW can have the option of allowing key
transitions whilst in the mode or not. If key transitions are required then tick this box.
4.8.2.6. Force Keyers When On
When the 3025SW is put into the emergency mode the keyer settings can be forced to a known state
using the "On-Air on Emergency" option for each keyer. If this is required then tick this box.
4.8.2.7. Restore Keyer Settings After
When the 3025SW is put into the emergency mode the 3025SW makes a note of which keyers are on-
air before the mode and will optionally restore these settings when the 3025SW comes out of the
emergency mode. If this restoration is required then tick this box.
To Next Page
Loading...
