3025SW Master Control Switching & Channel Branding
Page 156 Revision 1.0
The Sage port must be configured to output the type of data that the 3025SW is expecting. To configure
the sage decoder, follow the steps outlined below.
1) Press Menu
2) Scroll down to Devices
3) Press Enter
4) Scroll down to COM2 or COM6 (depending on the COM port you connected to)
5) Press Enter
6) Scroll down to Device Type
7) Press Enter
8) Scroll down to Generic CGEN
9) Press Enter
10) Enter Password
11) Scroll up to Go Back
12) Press Enter
Your Sage is now configured to work with the 3025SW. Proceed to section 8.3.6 to connect the audio
and GPI controls, to configure the 3025SW and verify that the connections are functioning as expected.
To Next Page
