evertz 3025SW - Page 29

3025SW Master Control Switching & Channel Branding
Revision 1.0 Page 15

Note: For the 3025SW the only rear plate available is the 3025SW-IO-BNC
Both the 3025EMC-IO-BNC and 3025SW-IO-BNC functionality has been included below for the
purposes of comparison.
IN 1 (PGM): Input 1 of the 3025SW Internal Router.
IN 2 (PST): Input 2 of the 3025SW Internal Router.
IN 3 (KEY 1): Either Input 3 of the 3025SW Internal Router OR Keyer 1 Key Input (depends on
EMC-Setup channel configuration).
IN 4 (FILL 1): Either Input 4 of the 3025SW Internal Router OR Keyer 1 Fill Input (depends on
EMC-Setup channel configuration).
IN 5 (KEY 2): Either Input 5 of the 3025SW Internal Router OR Keyer 2 Key Input (depends on
EMC-Setup channel configuration).
IN 6 (FILL 2): Either Input 6 of the 3025SW Internal Router OR Keyer 2 Fill Input (depends on
EMC-Setup channel configuration).
IN 7 (KEY 3): Input 7 of the 3025SW Internal Router.
IN 8 (FILL 3): Input 8 of the 3025SW Internal Router.
IN 9 (AUX 1): Input 9 of the 3025SW Internal Router.
IN 10 (AUX 2): Input 10 of the 3025SW Internal Router.
IN 11 (AUX 3): Input 11 of the 3025SW Internal Router.
IN 12 (EMG): Input 12 of the 3025SW Internal Router OR Emergency Input (depends on EMC-
Setup channel configuration)
IN 13 (DVE 1): Input 13 of the 3025SW Internal Router
IN 14 (DVE 2): Input 14 of the 3025SW Internal Router.
REF: Reference input. A clean Bi-Level or Tri-Level analogue signal is connected
and used for internal timing.
PGM BYP: Program Output Bypass source.
CLN BYP: Clean Output Bypass source.