3025SW Master Control Switching & Channel Branding
Page 34 Revision 1.0
5. Type .#98,N’ and the 3025SW will respond and show you the network settings that you have just
configured.
(SECONDARY IP)
6. Type “.#93,S192.168.10.100,255.255.255.0” or any appropriate settings for the second IP address
and Netmask. The format of the command is “.#93,S[Address],[Netmask]”. The 3025EMC will
respond with the same command to confirm that the settings have been received.
Wait for 30 seconds and then reboot the unit for the settings to take effect.
The Primary and Secondary IPs of the 3025SW MUST be on different Subnets.
The unit MUST be rebooted for the network settings/changes to take effect.
To Next Page
Loading...
