3025SW Master Control Switching & Channel Branding
Page 52 Revision 1.0
For VO1 (Voice-over 1) and VO2 (Voice-over 2), there are four options for the audio source for each of
the VO1 and VO2 buses. The options for the other buses varies depending on the VO selected.
Voiceover 1
AES: This configures the EMC to use the discrete AES audio that is connected to MADI inputs 1 and
2. For more details see section 2.9.2.
AES AP: Not Supported on the 3025SW.
Embedded: This configures the voiceover 1 bus to use de-embedded audio from a serial video
input. When this is configured the “De-embedder Source” drop-down menu becomes
available. Any of Key1, Fill1, Key2, Fill2, Key3, Fill3, Aux1, Aux2, Aux3, DVE1 and
DVE2 can be assigned to the voiceover 1 de-embedder. See Table 4-3 on page 49 for
details on how the input bus corresponds to the 3025SW-IO-BNC rear plate.
AES MADI: Not Supported on the 3025SW.
Voiceover 2
AES: This configures the EMC to use the discrete AES audio that is connected to MADI
inputs 3 and 4. For more details see section 2.9.2.
AES AP: Not supported on the 3025SW.
Embedded: This configures the voiceover 2 bus to use de-embedded audio from a serial video
input. When this is configured the “De-embedder Source” drop-down menu becomes
available. Any of Key1, Fill1, Key2, Fill2, Key3, Fill3, Aux1, Aux2, Aux3, DVE1 and
DVE2 can be assigned to the voiceover 2 de-embedder. See Table 4-3 on page 49 for
details on how the input bus corresponds to the 3025SW-IO-BNC rearplate.
AES MADI: Not Supported on the 3025SW.
Voiceover 3
Embedded: This configures the voiceover 3 bus to use de-embedded audio from a serial video
input. When this is configured the “De-embedder Source” drop-down menu becomes
available. Any of Key1, Fill1, Key2, Fill2, Key3, Fill3, Aux1, Aux2, Aux3, DVE1 and
DVE2 can be assigned to the voiceover 3 de-embedder. See Table 4-3 on page 49 for
details on how the input bus corresponds to the 3025SW-IO-BNC rearplate.
AES MADI: Not Supported on the 3025SW.
To Next Page
Loading...
