3. Project planning
3−3
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Contents of this chapter This chapter gives a summary of the planned axis systems for
the SPC200.
This chapter contains general information on the specifica
tions for permitted axis systems for the SPC200 contained in
WinPISA and how you can insert these into a project.
Further information Further information on permitted axis systems for the
SPC200
can be found in the system manual for the SPC200 or in the
manual for the stepping motor indexer module.
Further instructions on inserting an axis into a project can be
found in chapters 2 and 4.
To Next Page
