Festo SPC200 - Uploading Projects (Upload)

2. Project management
2−13
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
2.1.7 Uploading projects (Upload)
You upload a project from the SPC200 if:
 you have set up a new positioning system and you want
to use the hardware configuration in a new project,
 you want to edit a positioning system for which there is
no longer a project.
Please note
If a project contains hardware elements or NC programs
with NC commands or NC syntax, which is not supported
by the WinPISA version used, an appropriate message will
be displayed.
For safety reasons, an NC program cannot be downloaded
if non−supported NC commands or NC syntax are used.
This must be observed
especially if an older WinPISA ver
sion is used together with a new operating system version.
When a project is uploaded, the current hardware configur
ation as well as existing user programs and the position list
will be uploaded from the SPC200.
A project already open in WinPISA will first be closed.
The SPC200
must be connected to the PC (see Online mode)
if you wish to upload a project.
To upload a project:
1. Activate the Online mode from the [Online] menu using
the [Online mode] item or click on the Online mode on"
button on the toolbar.
2. Select the command [Project] from the [Online][Upload]
menu.
3. Enter the
name, directory and drive of the new project file
in the Determine project file" dialogue window just as
you do when creating a new project.