Festo SPC200 - Explanation of the NC Commands

5. Programming
5−46
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
5.5 Explanation of the NC commands
Identifying supported NC commands
Operating mode In Start/Stop mode all NC commands are supported. NC
commands, which are supported in the Record Select mode,
are marked as follows:
 permitted in operating mode: Start/Stop, Record Select
Axis type If the description refers to a particular axis type, this is also
marked.This means:
Axis type
Description
 Pneumatic axis The description of the NC command
refers to the pneumatic drives
 Stepping motor axis The description of the NC command
refers to the stepping motor axes
If no identification is given for a particular axis type, the com
mand description for both axis types is valid.