Contents and general instructions
XV
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Warning
If the tubing of your axis system has been incorrectly
connected and you enable the controller, the drive will
move at high speed and high acceleration into an end posi
tion, depending on the value of the supply pressure (con
trol direction swapped). This can lead to serious injury and
damage to components.
Always check the tubing before enabling the controller
with a 1−signal at the E NABLE input.
Checking that a program contains no syntactical errors is no
guarantee of error−free operation. When commissioning posi
tioning systems the user must therefore reckon with sudden
uncontrolled movements of the axes.
Target group
This manual is directed exclusively at technicians who are
trained in control and automation technology and who have
experience in installing, commissioning and diagnosing pro
grammable logic controllers (PLC), positioning systems and
field bus systems.
Service
If you have any technical problems, please contact your local
Festo Service.
To Next Page
Loading...
