Festo SPC200 - Information on Operating System Versions of the SPC200; And on Software Versions of Winpisa

Contents and general instructions
XXIII
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Information on operating system versions of the SPC200
and on software versions of WinPISA
The following operating system versions are supported by
this manual:
Operating system
Validity date Relevant WinPISA Validity date
Version 3.8 08−2001 Version 4.1 05−2001
Version 4.1a 06−2002
Version 4.63 10−2003 Version 4.31 10−2003
Version 4.82 12−2004 Version 4.41 12−2004
Version 4.90 03−2006 Version 4.5 03−2006
Version 4.93 11−2008 Version 4.51 11−2008
Please note
The operating system version and the WinPISA versions
are always downwards−compatible, i.e. a new version
supports the performance of the older versions.
Conversely the following applies: In each case the older
version does not support the extended and new perform
ances of the newer versions.
Caution
The functionality of the MMI (control panel) has been
frozen at the operating system status version 3.8. This
means that all new functions as from operating system
version 4.63 and earlier are no longer supported by MMI.
If the MMI is used for commissioning and with operating
system version 4.63 and earlier, the
switching cycle of the
ENABLE signal must be maintained during the movement
test, see System Manual for the SPC200.
This modification serves exclusively for increasing safety
for people as well as for the machine during commission
ing.