Contents and general instructions
XVIII
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Current information on WinPISA
Please note
Observe the current information in the file README.TXT in
the subdirectory \BIN of the WinPISA installation directory.
This manual contains the information necessary for operating
WinPISA version 4.5x (4.51 or 4.5).
WinPISA version 4.51 is downwards−compatible and supports
all SPC200 Smart Positioning Controllers with operating sys
tems as from version 3.8x. Some
correspondingly marked
functions are only available as from operating system version
4.93, 4.90, 4.82 or 4.63.
Information on operating system version 4.82 can be found in
the system manual for the SPC200 type P.BE−SPC200−... .
Please note
Projects and files created with WinPISA version 4.51 can
also be processed with earlier WinPISA versions. The fol
lowing restrictions apply:
With WinPISA 4.5: Project contains no settings for error
messages via fieldbus and for behaviour at stop.
With WinPISA 4.41: Project contains no DeviceNet2 field
bus module (none of the revisions
in Operation System
Version 4.90 not contained in Version 4.82 are sup
ported),
with WinPISA 4.31: Project contains no extended NC
syntax and no standard cylinder type DNCI−... (all modifi
cations to operating system version 4.82 compared with
version 4.63 will not be supported),
with WinPISA 4.1a: Project contains no new NC com
mands or
extended NC syntax, no standard cylinder type
DNCI−... and no swivel module type DSMI−... (all modifi
cations to operating system version 4.82 compared with
version 4.63 will not be supported).
To Next Page
Loading...
