Contents and general instructions
XIV
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Safety instructions
When commissioning and programming positioning systems
with WinPISA, you must at all costs observe the safety regula
tions listed in the system manual for the SPC200 as well as in
the operating instructions for the other components used.
The user must make sure that nobody is in the operating
range of the connected
actuators or axis system. The area of
possible danger must be protected using suitable measures
such as barriers or warning signs.
Warning
Pneumatic and electric axes move with great force and at
high speed.
Collisions can lead to serious injury or to damaged compo
nents.
Make sure that nobody can place his/her hand in the oper
ating range of the connected actuators or axes when the
system is connected to a source of power (i.e.
compressed
air, supply voltage).
Warning
Faults in parametrizing can cause injury to human beings
and damage to property if the controller is enabled with a
1−signal at the ENABLE input.
Enable the controller only if the axis system is correctly
installed and parametrized.
To Next Page
Loading...
