Contents and general instructions
III
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Festo conditions for using the software packages
I. Protection rights and scope of use
The product contains data−processing programs, files and the
associated product descriptions. These in their entirety are
referred to below as the software package". Festo or third
parties hold proprietary rights in respect of these software
packages. Insofar as the rights belong to third parties, Festo
has acquired the appropriate licences. Festo grants the
pur
chaser a licence to use the software packages under the fol
lowing conditions:
1. Scope of use
a) The purchaser of the WinPISA software package has the
right to use this for his own internal purposes as a tool for
Festo axes on any number of machines within his premises
(place of use).
This right of use shall extend only to the right
to run the software package on the central processing units
(machines) on the site in question.
b) The conditions of a) above shall also apply insofar as the
software package is linked to other programs or run in con
junction with these.
c) The
software package, alone or in conjunction with other
programs, may be copied and stored to any desired extent for
the purposes of data backup and faultfinding at the pur
chaser’s site. Copying for other purposes, especially for pas
sing on to third parties except as defined in Section 3 below,
editing into any
other form and any use other than that de
fined above shall not be permissible.
d) Any other form of use, in particular copying for other pur
poses, transmission to third parties except as defined in Sec
tion 3 below, editing into any other form and any use other
than that defined above
shall not be permissible.
2. Copyright notice
Each program contains a copyright notice. This notice must
be included in all copies, in all edited versions and in all parts
of the program that are linked to other programs.
To Next Page
Loading...
