4. Commissioning positioning systems
4−22
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
the tab card Nominal value input". Information on the
necessary entries can be found in the following sections.
Warning
Danger of collision!
Entering incorrect parameters will cause unforeseen move
ments of the connected actuators.
4. If the Online mode is activated, you can load the para
meters of the current tab card into the SPC200 with
Download" (with Upload" you can up−load them from
the SPC200).
Read the warning displayed.
5. Accept the parameters entered
with OK". The input can
be discarded using Cancel".
In the case of multi−axis systems, repeat steps 1 to 5 for
further axes.
The settings must then be downloaded into the SPC200 to
apply the configuration carried out on the individual tabs.
Loading the project into the SPC200" describes how to do
this.
To Next Page
Loading...
