5. Programming
5−3
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Contents of this chapter This chapter contains basic information on programming the
SPC200 with WinPISA. Both the coordinated and the auton
omous modes are explained and all the NC commands are
described.
You must determine the positioning and control sequence for
the axes of a positioning system in user programs. The pro
cedures for creating
user programs comply with DIN66025.
In this chapter you will learn how to:
create new user programs
open programs and edit them
manage the position list
check new or amended programs for correct syntax
compile programs for the SPC200
load the programs and the position list into the SPC200 or
read them out of
the SPC200.
WinPISA supports you in creating user programs for the
SPC200 by means of logical program management and a
user−friendly programming environment.
Further information Information on programming with the control panel type
SPC200−MMI−1 can be found in the system manual for the
SPC200.
To Next Page
Loading...
