Festo SPC200 - Page 199

5. Programming
5−13
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
The following settings are available for numbering:
Field
Description
from record number The record number from which numbering
is to start. The upper record number is
entered as a default, i.e. the program will
be numbered from the first record.
Transfer the default or enter a record
number which exists in the program.
to record number The record number to which numbering is
to take place. 99999" is entered as the
default, i.e. the program will be num
bered to record N99999, that is to the
end of the program.
Transfer the default or enter a record
number which exists in the program.
Step width Enter the increment for the sequential re
cord numbers. With step size 10"
numbering will be e.g.: N010, N020,
N030, etc.
starting with no. Enter here the record number at which
numbering is to start.