Festo SPC200 - Page 303

5. Programming
5−117
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
4. Download the selected programs to the SPC200 using
Download".
5. The progress of the transmission will be displayed in a
window. Wait until the process is complete.
The two bars show the progress of the transmission as a per
centage. The upper bar shows the progress for the whole
project, the lower bar shows the
progress for the project com
ponent currently being transmitted. This is shown under
Components".
If an error occurs during transmission, acknowledge the
message and repeat the download.
Once user programs have been downloaded to the SPC200
they become available for the positioning system and can be
started.
There are various ways of starting a
program.
 via I/O signals (see system manual for the SPC200),
 with the control panel (see system manual for the
SPC200),
in Debug mode in WinPISA (see chapter 6).
Further instructions on testing and starting programs can be
found in chapter 6 as well as in the user manual for the
SPC200.