Section 5: 9500B Procedure Mode - Access Guide 5.3-3
Final Width = 215mm
Descriptions assume 9500B/1100
5.3.3.5 Select the Subject UUT
Manufacturer
(Only available if more than one
manufacturer is listed in the
Procedure Card)
By the time the 'Select MANUFACTURER'
screen has been successfully opened, the 9500B
will have extracted a list of the manufacturers
whose models' procedures are contained in the
Procedure card memory. These it displays on
the screen for the user to choose. For example:
5.3.3.6 Select the Subject UUT
Model
By the time the 'Select MODEL' screen has
been successfully opened, the 9500B will have
extracted a list of the models whose procedure
is contained in the Procedure card memory.
These it displays on the screen for the user to
choose. For example:
Enter the UUT's Serial Number:
Use the alpha-numeric keypad to write the
serial number (20 characters max.) on the
screen. It will appear at the bottom of the
screen as you type. Then press the '↵' key or
the 'OK' screen key, after which the screen will
change to select the type of procedure required
ABORT returns to the 'Select USER NAME
...' screen.
Refer to paras 5.3.3 13, Fig 5.3.2.
After choosing the model, the next stage is to
enter the UUT serial number. Pressing the
'OK' screen key will cause the 9500B to transfer
to the 'Serial Number' screen.
ABORT returns to the 'Select USER NAME
...' screen.
Refer to paras 5.3.3 13, Fig 5.3.2.
5.3.3.7 Enter the Serial Number of
the Subject UUT
Having selected the UUT model, the 9500B
asks for the serial number to be entered so that
any results can be identified. This is done on
the following screen:
If the wrong card has been inserted:
Remove that card, insert another, then press
the NEW CARD screen key to tell the 9500B
that a different card has been inserted.
More than one manufacturer listed in
the new card:
The 9500B lists the manufacturers whose
models' procedures are resident in the new
card
Only one manufacturer listed in the
new card:
The 9500B transfers to the 'Select MODEL'
screen if only one manufacturer is listed.
Correct manufacturer selected:
After selecting the required manufacturer,
pressing the OK screen key will cause the
9500B to transfer to the 'Select MODEL' menu
screen.
ABORT returns to the
'Select USER NAME ...'
screen. Refer to paras 5.3.3 13, Fig 5.3.2.
If the wrong card has been inserted:
Remove that card, insert another, then press
the NEW CARD screen key to tell the 9500B
that a different card has been inserted.
More than one manufacturer listed in
the new card:
The 9500B lists the manufacturers whose
models' procedures are resident in the new
card. After selecting the required
manufacturer using the cursor keys,
pressing the OK screen key will cause the
9500B to transfer to the 'Select MODEL'
menu screen.
Only one manufacturer listed in the
new card:
The 9500B transfers to the 'Select MODEL'
screen if only one manufacturer is listed.
Correct Model selected:
After selecting the required model, pressing
the OK screen key will cause the 9500B to
download all the procedures for that model
into internal RAM. The card can then be
removed and used to load another instrument.
TODAY'S DATE TIME
OK
Select MANUFACTURER using cursor keys.
Press NEW CARD to read another card.
MANUF 1
MANUF 2
NEW
CARD
ABORT
TODAY'S DATE TIME
OK
Select MODEL using cursor keys.
Press NEW CARD to read another card.
MODEL 1
MODEL 2
NEW
CARD
ABORT
TODAY'S DATE TIME
OK
Enter the SERIAL NUMBER of UUT.
Confirm with OK.
ABORT
Serial Number :
To Next Page
Loading...
