Fortinet MR1 - Interface Vlan; Ip Address

128
5.3.1.5 interface vlan
This command is used to enter Interface-vlan configuration mode.
Syntax
interface vlan <vlanid>
<vlanid> - VLAN ID (Range: 1 - 3965).
Default Setting
None
Command Mode
Global Config
5.3.1.6 ip address
This command sets the IP Address, and subnet mask. The IP Address and the gateway must
be on the same subnet.
Syntax
ip address <ipaddr> <netmask>
no ip address
<ipaddr> - IP address
<netmask> - Subnet Mask
no - Restore the default IP address and Subnet Mask
Default Setting
IP address: 0.0.0.0
Subnet Mask: 0.0.0.0
Command Mode