Fortinet MR1 - Default-Information Originate; Default-Metric

361
6.6.2.4 default-information originate
This command is used to set the advertisement of default routes.
Syntax
default-information originate
no default-information originate
no - This command is used to cancel the advertisement of default routes.
Default Setting
Not configured
Command Mode
Router RIP Config
6.6.2.5 default-metric
This command is used to set a default for the metric of distributed routes.
Syntax
default-metric <1-15>
no default-metric
<1 - 15> - a value for default-metric.
no - This command is used to reset the default metric of distributed routes to its default value.
Default Setting
Not configured
Command Mode
Router RIP Config