Fortinet MR1 - Configuration Commands; Enable Rip

359
Syntax
show ip rip interface brief
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interfacet: Valid slot and port number separated by a forward slash.
IP Address: The IP source address used by the specified RIP interface.
Send Version: The RIP version(s) used when sending updates on the specified interface. The types are
none, RIP-1, RIP-1c, RIP-2.
Receive Version: The RIP version(s) allowed when receiving updates from the specified interface. The
types are none, RIP-1, RIP-2, Both
RIP Mode: RIP administrative mode of router RIP operation; enable, disable it.
Link State: The mode of the interface (up or down).
6.6.2 Configuration Commands
6.6.2.1 enable rip
This command resets the default administrative mode of RIP in the router (active).
Syntax
enable
no enable
no - This command sets the administrative mode of RIP in the router to inactive.
Default Setting
Enable
Command Mode
Router RIP Config