Fortinet MR1 - Area Virtual-Link Hello-Interval

334
Syntax
area <areaid> virtual-link <neighborid> dead-interval <1-65535>
no area <areaid> virtual-link <neighborid> dead-interval
<areaid> - Area ID.
<neighbor> - Router ID of the neighbor.
<1-65535> - The range of the dead interval is 1 to 65535.
<no> - This command deletes the OSPF virtual interface from the given interface, identified by <areaid>
and <neighborid>.
Default Setting
The default value of dead interval is 40 seconds.
Command Mode
Router OSPF Config
6.3.2.17 area virtual-link hello-interval
This command configures the hello interval for the OSPF virtual interface on the interface
identified by <areaid> and <neighborid>.
Syntax
area <areaid> virtual-link <neighborid> hello-interval <1-65535>
no area <areaid> virtual-link <neighborid> hello-interval
<areaid> - Area ID.
<neighborid> - Router ID of the neighbor.
<1-65535> - The range of the hello interval is 1 to 65535.
<no> - This command configures the default hello interval for the OSPF virtual interface on the interface
identified by <areaid> and <neighborid>.
Default Setting
The default value of hello interval is 10 seconds.
Command Mode
Router OSPF Config