263
Note: In essence, this the “free form” version of the IP DSCP/Precedence/TOS match
specification in that the user has complete control of specifying which bits of the IP Service
Type field are checked.
Default
None
Command Mode
Class-Map Config
5.12.2.12 match protocol
This command adds to the specified class definition a match condition based on the value of
the IP Protocol field in a packet using a single keyword notation or a numeric value notation.
Syntax
match protocol {<protocol-name> | <0-255>}
<protocol-name> is one of the supported protocol name keywords. The currently supported
values are: icmp, igmp, ip, tcp, udp. Note that a value of ip is interpreted to match all
protocol number values. To specify the match condition using a numeric value notation, the
protocol number is a standard value assigned by IANA and is interpreted as an integer from
0 to 255.
Note: This command does not validate the protocol number value against the current list
defined by IANA.
Default
None
Command Mode
Class-Map Config
5.12.2.13 match srcip
This command adds to the specified class definition a match condition based on the source
IP address of a packet.
Syntax
match srcip <ipaddr> <ipmask>
To Next Page
Loading...
