218
Syntax
radius-server msgauth <ipaddr>
<ipaddr> - is a IP address.
Default Setting
None
Command Mode
Global Config
5.8.4.7 radius-server primary
This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server is the one that is used by default for handling RADIUS
requests. The remaining configured servers are only used if the primary server cannot be
reached. A maximum of three servers can be configured on each client. Only one of these
servers can be configured as the primary. If a primary server is already configured prior to
this command being executed, the server specified by the IP address specified used in this
command will become the new primary server. The IP address must match that of a
previously configured RADIUS authentication server.
Syntax
radius-server primary <ipaddr>
<ipaddr> - is a IP address.
Default Setting
None
Command Mode
Global Config
To Next Page
Loading...
