Fortinet MR1 - Configuration Commands; Enable; No Area

326
Neighbor Is the neighbor interface of the OSPF virtual interface.
Hello Interval Is the configured hello interval for the OSPF virtual interface.
Dead Interval Is the configured dead interval for the OSPF virtual interface.
Retransmit Interval Is the configured retransmit interval for the OSPF virtual interface.
Transit Delay Is the configured transit delay for the OSPF virtual interface.
6.3.2 Configuration Commands
6.3.2.1 enable
This command resets the default administrative mode of OSPF in the router to active.
Syntax
enable
no enable
<no> - This command sets the administrative mode of OSPF in the router to inactive.
Default Setting
Enabled
Command Mode
Router OSPF Config
6.3.2.2 no area
This command removes an OSPF area.
Syntax
no area <areaid>
Default Setting