319
Syntax
show ip ospf database
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Messages
Router ID Is a 32 bit dotted decimal number representing the LSDB interface.
Area ID Is the IP address identifying the router ID.
LSA Type The types are: router, network, ipnet sum, asbr sum, as external, group member, tmp 1, tmp 2,
opaque link, opaque area.
LS ID Is a number that "uniquely identifies an LSA that a router originates from all other
self originated LSA's of the same LS type."
Age Is a number representing the age of the link state advertisement in seconds.
Sequence Is a number that represents which LSA is more recent.
Checksum Is to total number LSA checksum.
Options This is an integer. It indicates that the LSA receives special handling during routing
calculations.
6.3.1.4 show ip ospf interface
This command displays the information for the IFO object or virtual interface tables.
Syntax
show ip ospf interface <slot/port>
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Messages
IP Address Represents the IP address for the specified interface. This is a configured value.
Subnet Mask Is a mask of the network and host portion of the IP address for the OSPF interface. This
value was configured into the unit. This is a configured value.
OSPF Admin Mode States whether OSPF is enabled or disabled on a router interface. This is a configured
value.
OSPF Area ID Represents the OSPF Area Id for the specified interface. This is a configured value.
To Next Page
Loading...
Need help?
General