Fortinet MR1 - Show Ip Igmp Interface Membership

387
Privileged Exec
User EXEC
Display Message
Slot/Port Valid slot and port number separated by a forward slash.
IGMP Admin Mode This field displays the administrative status of IGMP. This is a configured
value.
Interface Mode This field indicates whether IGMP is enabled or disabled on the interface. This is a
configured value.
IGMP Version This field indicates the version of IGMP running on the interface. This value can be
configured to create a router capable of running either IGMP version 1 or 2.
Query Interval (secs)This field indicates the frequency at which IGMP Host-Query packets are transmitted
on this interface. This is a configured value.
Query Max Response Time (1/10 of a second)This field indicates the maximum query response time
advertised in IGMPv2 queries on this interface. This is a configured value.
Robustness This field displays the tuning for the expected packet loss on a subnet. If a subnet is expected
to be have a lot of loss, the Robustness variable may be increased for that interface. This is a configured
value.
Startup Query Interval (secs) This value indicates the interval between General Queries sent by a Querier
on startup. This is a configured value.
Startup Query Count This value is the number of Queries sent out on startup, separated by the Startup
Query Interval. This is a configured value.
Last Member Query Interval (1/10 of a second) This value indicates the Maximum Response Time
inserted into Group-Specific Queries sent in response to Leave Group messages. This is a configured
value.
Last Member Query Count This value is the number of Group-Specific Queries sent before the router
assumes that there are no local members. This is a configured value.
7.2.1.4 show ip igmp interface membership
This command displays the list of interfaces that have registered in the multicast group.
Syntax
show ip igmp interface membership <multiipaddr> [detail]
< multiipaddr > - A multicast IP address..
[detail] - Display details of subscribed multicast groups.
Default Setting
None
Command Mode
Privileged Exec
User EXEC
Display Message