341
Syntax
ip ospf cost <1-65535>
no ip ospf cost
< 1-65535 > - The range of the cost is 1 to 65535.
<no> - This command configures the default cost on an OSPF interface.
Default Setting
The default cost value is 10.
Command Mode
Interface Config
6.3.2.29 ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface.
Syntax
ip ospf dead-interval <1-2147483647>
no ip ospf dead-interval
< 1-2147483647> - It is a valid positive integer, which represents the length of time in seconds that a
router's Hello packets have not been seen before its neighbor routers declare that the router is down.
The value for the length of time must be the same for all routers attached to a common network. This
value should be some multiple of the Hello Interval (i.e. 4).
<no> - This command sets the default OSPF dead interval for the specified interface.
Default Setting
The default dead interval is 40 seconds.
Command Mode
Interface Config
To Next Page
Loading...
