260
no match class-map <refclassname>
<refclassname> is the name of an existing DiffServ class whose match conditions
are being referenced by the specified class definition.
Note: There is no [not] option for this match command.
Default
None
Command Mode
Class-Map Config
5.12.2.7 match dstip
This command adds to the specified class definition a match condition based on the
destination IP address of a packet.
Syntax
match dstip <ipaddr> <ipmask>
<ipaddr> specifies an IP address.
<ipmask> specifies an IP address bit mask; note that although similar to a standard subnet mask, this bit
mask need not be contiguous.
Default
None
Command Mode
Class-Map Config
5.12.2.8 match dstl4port
This command adds to the specified class definition a match condition based on the destination layer 4 port of
a packet using a single keyword or numeric notation or a numeric range notation.
Syntax
match dstl4port {<portkey> | <0-65535>}
To specify the match condition as a single keyword, the value for <portkey> is one of the
supported port name keywords. The currently supported <portkey> values are: domain,
To Next Page
Loading...
