193
Global Config
5.7.2.3 username snmpv3 encryption
This command specifies the encryption protocol and key to be used for the specified login
user. The valid encryption protocols are none or des. The des protocol requires a key,
which can be specified on the command line. The key may be up to 16 characters. If the des
protocol is specified but a key is not provided, the user will be prompted to enter the key. If
none is specified, a key must not be provided. The <username> is the login user name for
which the specified encryption protocol will be used.
Syntax
username snmpv3 encryption <username> {none | des [<key>]}
no username snmpv3 encryption <username>
<username> - is the login user name.
des - des encryption protocol.
none - no encryption protocol.
no - This command sets the encryption protocol to none. The <username> is the login user name for
which the specified encryption protocol will be used.
Default Setting
No encryption
Command Mode
Global Config
5.8 Security Commands
5.8.1 Show Commands
5.8.1.1 show users authentication
This command displays all users and all authentication login information. It also displays the
authentication login list assigned to the default user.
To Next Page
Loading...
Need help?
General