Fortinet MR1 - Maximum-Paths; Bootp;Dhcp Relay Commands; Show Bootpdhcprelay

346
6.3.2.37 maximum-paths
This command sets the number of paths that OSPF can report for a given destination where
<maxpaths> is platform dependent.
Syntax
maximum-paths <1-1>
no maximum-paths
< 1-1 > - The maximum number of paths that OSPF can report for a given destination. The range of the
value is 1 to 1.
Default Setting
The default value is 1.
Command Mode
Router OSPF Config.
6.4 Bootp/DHCP Relay Commands
6.4.1 show bootpdhcprelay
This command displays the BootP/DHCP Relay information.
Syntax
show bootpdhcprelay
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message