Fortinet MR1 - Snmptrap Mode; HTTP Commands; Show Ip Http

154
Default Setting
None
Command Mode
Global Config
5.3.5.5 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Syntax
snmptrap mode <name> <ipaddr>
no snmptrap mode <name> <ipaddr>
<name> - SNMP trap name.
<ipadd> - an IP address.
no - This command deactivates an SNMP trap. Trap receivers are inactive (not able to receive traps).
Default Setting
None
Command Mode
Global Config
5.3.6 HTTP commands
5.3.6.1 show ip http
This command displays the http settings for the switch.
Syntax
show ip http