591
8.2.5 QOS Menu
8.2.5.1 Managing Access Control Lists
Configuring IP Access Control List Configuration Page
An IP ACL consists of a set of rules which are matched sequentially against a packet.
When a packet meets the match criteria of a rule, the specified rule action
(Permit/Deny) is taken and the additional rules are not checked for a match. On this
menu the interfaces to which an IP ACL applies must be specified, as well as
whether it applies to inbound traffic. Rules for the IP ACL are specified/created using
the IP ACL Rule Configuration menu.
Selection Criteria
IP ACL - Make a selection from the pulldown menu. A new IP Access Control List may be created or
the configuration of an existing IP ACL can be updated.
Configurable Data
IP ACL ID - IP ACL ID must be a whole number in the range of 1 to 99 for IP Standard Access Lists and
100 to 199 for IP Extended Access Lists.
Non-Configurable Data
Table - Displays the current and maximum number of IP ACLs.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect immediately.
These changes will not be retained across a power cycle unless a save is performed.
Delete - Removes the currently selected IP ACL from the switch configuration.
To Next Page
Loading...
