81
This command configures the tagging behavior for all interfaces in a VLAN to be enabled. If
tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Syntax
switchport tagging all <vlanid>
<vlanid> - VLAN ID (Range: 1 –3965).
all - All interfaces
no - This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging is
disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification number.
Default Setting
Disabled
Command Mode
Global Config
5.2.3.15 switchport priority
This command configures the default 802.1p port priority assigned for untagged packets for
a specific interface.
Syntax
switchport priority <0-7>
<0-7> - The range for the priority is 0 - 7.
Default Setting
0
Command Mode
Interface Config
To Next Page
Loading...
