Fortinet MR1 - Ip Domain-Lookup; Ip Name-Server

354
Default Setting
None
Command Mode
Privileged Exec
6.5.2.5 ip name-server
This command specifies the address of one or more domain name servers to use for
name-to-address resolution. There are maximum 6 entries in the Domain Name Server
Table.
Syntax
ip name-server <ipaddr>
no ip name-server <ipaddr>
< ipaddr > - IP address of the Domain Name Servers.
<no> - Remove the corresponding Domain Name Server entry from the table.
Note - The listed name servers are queried in the specified sequence until a response is received, or
the end of the list is reached with no response.
Default Setting
None
Command Mode
Privileged Exec
6.5.2.6 ip domain-lookup
This command enables the IP Domain Naming System (DNS)-based host name-to-address
translation.
Syntax
ip domain-lookup
no ip domain-lookup