130
<dhcp> - Obtains IP address from DHCP.
<none> - Obtains IP address by setting configuration.
Default Setting
None
Command Mode
Interface-Vlan Config
5.3.1.9 ip filter
This command is used to enable the IP filter function.
Syntax
ip filter
no ip filter
no – Disable ip filter.
Default Setting
Disabled
Command Mode
Global Config
This command is used to set an IP address to be a filter.
Syntax
ip filter <ipaddr>
no ip filter <ipaddr>
<ipaddr> - Configure a IP address to be a filter.
No - Remove this filter IP address.
To Next Page
Loading...
