Fortinet MR1 - Page 152

152
no snmp trap link-status
no - This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. (See ‘snmpserver enable
traps linkmode’ command.)
Default Setting
Disabled
Command Mode
Interface Config
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (See ‘snmpserver
enable traps linkmode’ command.)
Syntax
snmp trap link-status all
no snmp trap link-status all
all - All interfaces.
no - This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see “snmpserver enable
traps linkmode”).
Default Setting
Disabled
Command Mode
Global Config